Regime Scalper Lite is an MQL5 Expert Advisor for MetaTrader 5, version 1.32. It is a simplified M1 regime scalper, built from Regime Scalper v3.10 without the AI layer.
The EA is designed for BTCUSD, XAUUSD and ETHUSD. Distances are measured in ATR. It keeps regime detection, higher-timeframe bias, and ATR stops, and drops the AI layer, basket logic, daily target and recovery mode, and tick-velocity buffers used in the flagship scalper. The default mode is NORMAL. Position size is a fixed lot.
Nothing on this page is a performance claim. No Expert Advisor can guarantee profit. Test on a demo account before using live funds.
Who it is for
- Traders who want a simpler M1 regime scalper without the AI layer.
- Intended for BTCUSD, XAUUSD (gold) and ETHUSD.
- Four modes: NORMAL (default), EARLY, SCALP, or ALL.
- You should test on a demo account before using live funds. No Expert Advisor can guarantee profit.
How it decides
A regime filter uses ADX and the efficiency ratio, with hysteresis and a short confirmation count so the regime does not flip on a single bar. A higher-timeframe EMA slope (M5 by default, with an optional M15 filter) is used as a bias and can block trades that go against it.
There are four modes. NORMAL trades both trend and range setups. TREND entries in NORMAL require several conditions to pass together, including EMA alignment, a DI gap, HTF slope, and a break of the last bar extreme. RANGE entries fade a touch of the Bollinger band with an RSI filter. EARLY looks for a momentum breakout of the recent high or low. SCALP looks for a pullback to the fast EMA and uses tighter ATR stops and targets. ALL runs the other three modes together.
Exits use ATR stops and targets (a broker-side stop is on by default), profit locks, trailing, and an optional reversal exit when enough of five signals turn against the trade. RANGE trades can also be closed on a flip bar or a close beyond the band.
Risk controls
- A cost filter that skips a trade if the target is too small relative to spread and round-trip commission.
- A maximum spread in ATR, and an optional volatility-ratio filter.
- A basket risk cap on the combined stop-loss exposure of open trades (default 0.50% of equity), a daily loss cap (default 3%), a consecutive-loss pause, and cooldowns after losses in each mode.
- A maximum of two open trades, in the same direction only, with a minimum time between entries and an optional one-entry-per-bar rule (on by default).
- By default the EA sends a broker stop with each trade. A testing switch can open trades without a broker stop, but the EA refuses to start that way on a real account unless you explicitly allow it, and an emergency ATR close can still apply.
Recommended use
| Platform | MetaTrader 5 |
|---|---|
| Version | 1.32 |
| Symbols | BTCUSD, XAUUSD (gold) and ETHUSD |
| Timeframe | M1 |
| Account type | Raw-spread or ECN (low-spread) account recommended |
| First use | Attach the EA on a demo account and confirm your inputs before any live use |
Key settings
| InpMode | NORMAL (default). Other options: EARLY, SCALP, or ALL. |
|---|---|
| InpMagic | 7780010 |
| InpLots | 0.01 |
| InpMaxPositions | 2 (same direction only) |
| InpUseStopLoss | true |
| InpTrendSL_ATR / InpTrendTP_ATR | 1.00 / 1.50 |
| InpDailyLossPercent | 3.0% (0 = off) |
| InpCommissionPerLotSide | 3.50 USD per lot per side (used in the cost filter) |
Requirements
- A MetaTrader 5 terminal and a broker account you control.
- Each copy is compiled for and locked to the buyer's MT5 account number.
- A raw-spread or ECN (low-spread) account is recommended, because the cost filter’s commission default assumes tight spread plus commission rather than a wide markup.
- You remain responsible for inputs, risk limits, and supervision while the EA is running.
Trading leveraged products is high risk. This is not financial advice. Past performance is not indicative of future results. Read the risk disclaimer.